Sundance SMT377 User Manual download pdf (Page 14)

Version 1.1 Page 14 of 22 SMT377 User Manual

Installation.

The minimum system requirements needed to run an SMT377 on a PC is a carrier

board providing + and –12 Volts and at least one C6x TIM transmitter at reset

ComPort (CommPort 0,1 or 2) to allow configuration of the SMT377.

Follow these steps to install the SMT377 module onto a carrier board:

- Place the SMT377 module into the second, third or fourth TIM sites

on the carrier board.

- Make sure that the board is firmly seated. Add a bold and a screw on

both mounting holes, located on two opposite corners. Tight them to

make a good connection and provide 3.3 Volts to the module.

- Place a C6x TIM board in the first TIM site (PCI connector side), by

following the instructions specified in the relevant document.

- Connect CommPort3 of the SMT377 to a transmitter at reset

CommPort on the C6x module (0, 1 or 2).

The following example shows the example of an SMT376 and an SMT377v2 on an

SMT310Q PCI carrier board:

Figure 3 - Example of installation on an SMT310Q.

The next picture shows the example of CommPort connection of an SMT376 to an

SMT377 at the back of an SMT310Q:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Sundance SMT377 User Manual Page 14